PDA

View Full Version : Carb

Lhudgins1968
08-01-2004, 10:55 AM
Need Help Please!
I have just installed a ADA Carb on a 47cc pocket bike, it will start but will not run long enough to take off. Any suggestions will be appreciated. :confused:
Brooks
08-01-2004, 06:31 PM
Check your installation here (http://www.billetboard.com/showthread.php?t=1281).

Check your carb settings here (http://www.billetboard.com/showthread.php?t=1312).

Start with those setting and adjust in small increments(1/16th turn) from there.
ScReWeDuP
08-01-2004, 08:37 PM
make sure you installed it correct
Lhudgins1968
08-03-2004, 02:39 PM
Thank You!!!!!!!!!
JBonnardel
08-03-2004, 02:50 PM
Check to see that the carb gasket isnt on backwards!
mega
08-03-2004, 06:13 PM
i made a writeup on installing the ADA HP Carb (WB 668) check it out, and i hope this helps.

http://moto.staticlabs.org/tech/hpcarb/index.html

:D :o
Lhudgins1968
08-03-2004, 10:19 PM
thank you for the ins. notes and pics. big help i got out of the shop today running some better but just not right,when you gave it the gas it still try to cut off with you, so do i trun the high or the low set screw up or down :confused:
mega
08-04-2004, 09:13 PM
at WOT (wide open throttle) and you get the bog plus with a lot of smoke, oil film etc, turn the high speed needle clockwise 1/16 to 1/8 turn to lean the A/F mixture. (the case of running rich.) another good tip, is to stay with the same gas/oil ratio after you tune your carb. hope that helps.