help please. im so confused... (bf question)

[vegas ped rider]

ok... heres my problem. i have a bf (bigfoot) with an he26, 167/603 (right now a 167 cuz it runs better imo), uni, a s1, and i think an 800 bm spindle. ok well, when i give it gas, it starts to go but super slow, then i have to push it and hump like crazy to get the power band to kick in. once my pb is going, im good from there. but right up to that i have a massive dead spot. whats this from? i also have tuned it like 20 thousand times and no difference???

also, as i tighten my motor to my wheel (w/ a lockout) i have to push more, but if i take tension off it bobs back and forth like crazy. i tried putting mroe pressure in the tire and it didnt do anything. these problems ive had since day 1 with this goped. my sport has no problems with this. someone please help me out.

[SIKKSS-RYDER]

snicker snicker, no advice but i did find it funny that the subject asks for advice on a "bf" question.....

[vegas ped rider]

typing bigfoot made it too long. then i deleted some other stuff and didnt change that.

[pedhead7]

Has it always done this?

When Was the last time you changed the Ring?
Is your cylinder ported??

...Its 90 percent your pipe though. Its a TOPEND pipe, so it lags till you get on your powerband. Stick a can on it and try it out, itll be much better. If your convinced on running a pipe, get a S2.

[vegas ped rider]

the ring if pretty much brand new... and ill put my xcan on and see. i remember having a meyer can on there and having the same problem tho. lemme try the x and see, ill let ya know