Announcement

Collapse

General Forum Rules

This forum is open to all brands and aftermarket products.


No flaming or insulting other members, everyone is entitled to their own opinion.


Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!


No profanity. Dropping f-bombs doesn't make you cool.


Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

*** Ada 717 Water Routing ***

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • *** Ada 717 Water Routing ***

    Greetings Marv,

    I have purchased (slightly used) one of your ADA Billet Heads/WaterJacket 39cc Domes for my 1996 HX SS 717.

    What is the proper water routing through a ADA WaterJacket/Domes on the 717 engine ?


    Domes--->Cyls--->Factory Pipe "Y" Manifold---->FPP Cast Exhaust Manifold---->Overboard through FPP 1/2" Fitting on FRONT of FPP casting AND 5/16" Fitting on "Belly-Pipe" ?

    --- or

    FPP front 1/2" Fitting on FRONT of FPP Exhaust Casting fitting---------->FPP "Y" Manifold--->Cyls--->Domes--->Overboard through Tops of ADA Billet head (DOMES) ?

    --- or

    FPP "Y" Manifold (Both Ex. Port Cooling Galleries 1/8" NPT Tapped into from underside)--->Cooling Water INTERNALLY split to Both FPP Cast Exhaust Manifold (exiting the FRONT 1/2"fitting----->Overboard) and Cylinders----->Domes-- >Exiting tops of Domes-------> Overboard ?

    Any Engine/FPP Water restrictor Points//Sizes to consider ?

    Can you send me a diagram of this preferred routing method ?

    HX 717 SS Engine running a FPP w/ECWI and Flow Control Valve (set to 3500rpm) @ the FPP Stinger

    Any Further Suggestions ?

    Thank You,

    David
    David_HX

  • #2
    ....... anyone home ?
    David_HX

    Comment

    Working...
    X