Carb

[Lhudgins1968]

Need Help Please!
I have just installed a ADA Carb on a 47cc pocket bike, it will start but will not run long enough to take off. Any suggestions will be appreciated.

[Brooks]

Check your installation here.

Check your carb settings here.

Start with those setting and adjust in small increments(1/16th turn) from there.

[ScReWeDuP]

make sure you installed it correct

[Lhudgins1968]

carb

Thank You!!!!!!!!!

[JBonnardel]

Check to see that the carb gasket isnt on backwards!

[mega]

i made a writeup on installing the ADA HP Carb (WB 668) check it out, and i hope this helps.

http://moto.staticlabs.org/tech/hpcarb/index.html

[Lhudgins1968]

carb

thank you for the ins. notes and pics. big help i got out of the shop today running some better but just not right,when you gave it the gas it still try to cut off with you, so do i trun the high or the low set screw up or down

[mega]

at WOT (wide open throttle) and you get the bog plus with a lot of smoke, oil film etc, turn the high speed needle clockwise 1/16 to 1/8 turn to lean the A/F mixture. (the case of running rich.) another good tip, is to stay with the same gas/oil ratio after you tune your carb. hope that helps.