Announcement

Collapse

General Forum Rules

This forum is open to all brands and aftermarket products.


No flaming or insulting other members, everyone is entitled to their own opinion.


Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!


No profanity. Dropping f-bombs doesn't make you cool.


Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

Gsr46r help please!!!!

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Gsr46r help please!!!!

    Hi everyone I'm new to GoPed scene I just recently bought a new sgsr46r GoPed completely stock haven't even rode it yet I have bought a few things for Ddm such as Ada 13:1 headkit - 1mm stroker crank - .020 copper cylinder gasket race pole billet engine mount gas tank cover gas cap 8- 68 gearing as well as the stock 6-76 gearing also Billet rims a new deck new air filter Billet manifold and also ordered a chrome version The Jet Pro Race rhino pipe I also bought red clutch springs and also yellow clutch springs I also bought a GSR tensioner and some other miscellaneous stuff I also bought Redline 2-stroke oil I'll be running 91 octane I have a few questions to ask my location is 81 ft above sea level temperature ranges between 68 to 103 my question is what do you think my carb settings should be should I just leave it stock and not touch it again I haven't even started the scooter not until I put my upgrades on it please any help would be greatly appreciate it...

  • #2
    Sounds like you should be running higher octane. Likely going to hit detonation with such high temps and all that raised compression.

    Comment


    • #3
      So run higher octane or run say 24:1

      Comment


      • #4
        Again haven't done nothing just unboxed it

        Comment


        • #5
          91 octane sucks. Perhaps others can chime in but seems you have setup a lot of performance edits that need highest octane.

          Comment

          Working...
          X