Announcement

Collapse

General Forum Rules

This forum is open to all brands and aftermarket products.


No flaming or insulting other members, everyone is entitled to their own opinion.


Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!


No profanity. Dropping f-bombs doesn't make you cool.


Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

Loose clutch bell assembly

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Loose clutch bell assembly

    Just got a new clutch but upon installation I noticed the bell/bearings is a bit loose. Is there any way to repair this aside from replacing parts? Or is it supposed to be a little loose? I have the exact situation as in this video https://youtu.be/YmG7FhX86kA

    It's a gp460

  • #2
    Mine was the bell itself not fitting tightly in the bearing, and the bearing ended up being fine. I'd fix it.

    Comment


    • #3
      Originally posted by dane795 View Post
      Mine was the bell itself not fitting tightly in the bearing, and the bearing ended up being fine. I'd fix it.
      Im almost positive I'm having that same problem. My bearing is in the proper place and spins perfectly fine but I feel like there's too much play with the bell still. How did you fix it? New bearing? Or maybe just re-tighten everything?

      Comment


      • #4
        I upgraded to the ADA clutch bell. It was a really tight fit with the bearing, I put it in the freezer first and still had to tap it in with a hammer. So far so good though! I had a new bearing on hand too but it seemed to be in identical condition to the old one. Also mine is the 54mm setup (RC engine) but I think all the same concepts should apply.
        Last edited by dane795; 08-02-2020, 10:12 PM.

        Comment

        Working...
        X