Announcement

Collapse
No announcement yet.

Cant install stock g260rc HP carb!

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Cant install stock g260rc HP carb!

    I don't know why but i thought I installed the carb correctly but there's alot of tension.. like i can't get the full pull from my throttle. Has anyone else had this problem? Does anyone have or know of a pic with it correctly installed? Thanks!

  • #2
    u either have to tune it...or if ur talking about it goin against the grip u have to turn ur one screw part that is on ur throttle cable
    03 bigfoot w/and lh,s2,800,airfilter.....soon to come gsr40

    Comment


    • #3
      By the way.. i'm using stock goped cables.. should i maybe trim some of the plastic covering off the end? Thanks!

      Comment


      • #4
        what exactly is binding or catching or sticking, and where. mine did this to if thats what it is doing. if it is the same situation there r 2 things u need to do.

        there is a screw type thing that goes on to the carb bracket, and the throtle cable goes through it. try messing with it"screwing it up and down" till the swivle gets full range of motion and is not sticking.


        2nd there is not enough slack of ur cable and its pulling and makeing the cable bind. pull or work as much exsess slack as u can from the entire length of the cable till u reach the carb, and it should not bind. and if this is ur prob put a zip tie and the frame to hold the cable in place so it does not slide back again "this happend to me while i was going down hill and my throtle stuck"

        hope this helps
        and use trimming as ur last option, if u take to much off u will have to buy new cable because u will not be able to reach full throtle.
        Last edited by motoxracer; 03-29-2004, 09:12 PM.
        to goped.... or not to goped.... that is the question

        Comment


        • #5
          On my G260RC, my linkage on my carb was hitting my shroud. I took a Dremel and trimmed it down a bit...problem solved.
          ? Coast Ped ? Dave's Discount Motors (DDM) ? Earth Surfer Products (ESP) ?

          www.keithkman.com

          Comment


          • #6
            and i typed all that for nothing
            to goped.... or not to goped.... that is the question

            Comment


            • #7
              Yeah, that was the problem. I wish I would've known that before I "tried" trimming some plastic to give my carb some cable slack. Can you guess what happened next? Yep i'm ordering a new cable

              Comment


              • #8
                oh and thx for the replies

                Comment


                • #9
                  No problem, glad I could help!
                  ? Coast Ped ? Dave's Discount Motors (DDM) ? Earth Surfer Products (ESP) ?

                  www.keithkman.com

                  Comment


                  • #10
                    A Bigfoot cable will give you more slack if you have a Sport, x-ped etc.
                    Stalker In, Stalker Out

                    Comment

                    Working...
                    X
                    😀
                    🥰
                    🤢
                    😎
                    😡
                    👍
                    👎