General Forum Rules

This forum is open to all brands and aftermarket products.

No flaming or insulting other members, everyone is entitled to their own opinion.

Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!

No profanity. Dropping f-bombs doesn't make you cool.

Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

Stroker Crank

  • Filter
  • Time
  • Show
Clear All
new posts

  • Stroker Crank

    I bought the 1 mm stroker crank from ADA and the stock piston doesn't fit. The skirts touch the counter-weight when the piston would be at bottom dead center. Is there a smaller piston I need to get? Will the crank still fit in the crankcase? (I didn't even try to install it) Thanks for any help anyone can give.

  • #2
    You need to shave the skirts on a bench grinder. Do small increments and then try. Becareful not to take to much off.
    Ada All the way.