General Forum Rules

This forum is open to all brands and aftermarket products.

No flaming or insulting other members, everyone is entitled to their own opinion.

Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!

No profanity. Dropping f-bombs doesn't make you cool.

Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

DDM Race Bars

  • Filter
  • Time
  • Show
Clear All
new posts

  • DDM Race Bars

    just ordered the DDM race bars with the ada cross pad and bars ... how do i wire the kill switch so i still have use of it. I just learned the hard way when replacing all of my cables on my other peds with braided carbon fiber especially the throttle ... the OEM kill has to be sliced out of the cable housing with the throttle and hooked up to the killswitch on the bars and the engine it the same ... but Im concerned about the anodized bars and if a connection on the kill will be able to be made ... a sport stuck at WOT is a wild time lol .....

  • #2
    The ground will transfer through the anodizing, I found out the hard way.
    Hell Fab


    • #3
      so i have no use of my kill with the ada bars...