will not take off from start???? help.

[Richybob]

we just rebuilt my super big foot and put a hp carb,x-can, and air filter on it.\
if we push start it it will not take off until you push it really fast????
please advise.

[pedhead7]

we just rebuilt my super big foot and put a hp carb,x-can, and air filter on it.\
if we push start it it will not take off until you push it really fast????
please advise.

Double check your carb settings.

[Richybob]

i have them set on the starting point. it runs great on the top end but you have to get the rpms up before it has any power.

[Brooks]

If you have a Super Bigfoot, the lock-down may be too tight.

[Richybob]

how tight should it be????

[blingslowped]

holy **** thats wat my sport does wat size spindle u gotz me a 900 blkm help every body

[Brooks]

how tight should it be????

Just tight enough si the spindle doesn't slip, but not so tight that it robs power. You need to adjust the lockdown to where the spindle slightly slips, then tighten it a little at a time until it just stops slipping. Also run about 35-40 psi in the rear tire.

[Brooks]

holy **** thats wat my sport does wat size spindle u gotz me a 900 blkm help every body

That is probably because you have a .900" diameter spindle and you had to cram it in there! It's binding up the motor. There is not enough adjustment on the rear wheel of a Sport/X-Ped for the larger spindles. Plus the frames seem to vary so one person may be able to get a large spindle to fit, but someone else may not. Bigger is not always better/faster.

[blingslowped]

w/e and size/speed does matter wen u ridin wid ure other pedder pimps TOPENDROCKS 900. AND UP 4 LIFE!!!!!!!!!!!!!!!!!!!

[blingslowped]

OH ya i swiched from a 950 to a 900 case i split my crank in half 150 bucks fer a new spindle turner!!!!!!(motor)

[pedhead7]

Spindles that big are a Joke. Even if your 100 Pounds, your bottem end sucks, and its hell on cranks.

[jumpman]

Spindles that big are a Joke. Even if your 100 Pounds, your bottem end sucks, and its hell on cranks.

thats true on all gopeds except pro60's. i have a 1.000 and it hauls off the line. but i know ur talkin bout LH's and RC's

[wimmig02]

Spindles that big are a Joke. Even if your 100 Pounds, your bottem end sucks, and its hell on cranks.

Ehe yeah all users above .750 should be shot out back.

[blingslowped]

ya cept wen im kikin ur *** in topend

[linkinped]

nothing

if you have a .900 and every thing else you need to hold the back tire up and pull it alot un till it starts then it will be warm to start eazy or get a .720 or .800