Spindle is slipping on motor

[miles105]

Since GPN is down I guess I will post here. I am building a SBF but I cant get the spindle on the crank withought having it slip when you go to push it. I know that it is slipping on the motor and not on the tire. The SBF has 3rd bearing support by mlc if that makes a difference. SO how do you install a spindle. Thanks!

[pedhead7]

??????
What kind of Spindle?
Spindel instalation is Straight forward. Slip the end with the bigger hole on to the Crank, and then Tighten the Bolt.

[miles105]

got it on just had to use a truck load of thread lock and tap it on a bit. The 3rd was making it a little hard to get the spindle on all the way. But now my problem is that I am hsving trouble starting the motor now. You got any tricks, its a brand new motor. I set it to specified factory settings and the motor is turning over. It just dosnt continue to turn. So please give any ideas or tricks to starting a stubborn motor. Thanks!

[pedhead7]

Try priming the Carb. Press the lil bubble on the top of the carb untill if fills all the way.

[CORVETTEJIM1968]

starting

got it on just had to use a truck load of thread lock and tap it on a bit. The 3rd was making it a little hard to get the spindle on all the way. But now my problem is that I am hsving trouble starting the motor now. You got any tricks, its a brand new motor. I set it to specified factory settings and the motor is turning over. It just dosnt continue to turn. So please give any ideas or tricks to starting a stubborn motor. Thanks!

i have noticed that i pull real hard on the starter vs other people what im trying to say is i have seen this before when they cant start it but i can some engines are tempermental on start up typically the engines i build are hard to start so i use starter fluid to get the 1st start.once its warmed up i dont have the problem anymore.you can get starter fluid in a spray can for as little as a dollar.just use it when worst comes to worst.