If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hey, when i look at my fuel lines i see alot of little air bubbles in them and when i go to start my ped it doesnt start. Are the air bubbles in the lines the reason my ped is not starting? And how do i get rid of the air bubbles?? thanks
the bubbles are supost to be there, its like that on mine to. there shouldent be alot of bubbles in the lines, if there is its beause your out of gas or your fuel filter is clauged. if it dosent start it could be because your priming it to much, you shouldent prime it more than 10 times.
SPORT: ADA stalker exhaust, ADA 167 hp carb, ADA red billet fancover, ADA red block off, ADA red billet brake, K&N filter, rocket key, ADA velocity stack, ADA .800 spindle, ADA 3rd bearing support, red grips, UMI red gas cap, red tank cover
Incorrect. Priming your carb does not shoot gas into the motor so you could have a ball doing it all you want. There really should not be any bubbles in the "in" line once you prime it a few times. If there is, you have a leak. Don't worry about the yellow 'out" line.
sry about that i guess i was wrong! i always thought that if you primed it to much you could flood the engine. on my goped there are always about 3 little bubbles in the line.
SPORT: ADA stalker exhaust, ADA 167 hp carb, ADA red billet fancover, ADA red block off, ADA red billet brake, K&N filter, rocket key, ADA velocity stack, ADA .800 spindle, ADA 3rd bearing support, red grips, UMI red gas cap, red tank cover
Comment