Announcement

Collapse

General Forum Rules

This forum is open to all brands and aftermarket products.


No flaming or insulting other members, everyone is entitled to their own opinion.


Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!


No profanity. Dropping f-bombs doesn't make you cool.


Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

Table of speeds for spindle sizes, for 10inch

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Table of speeds for spindle sizes, for 10inch

    Someone was nice enough to post a table of gear and sprocket combos for chains, running air tires. I searched for one for spindles, as my buddy and I are trying to figure out how fast we should aim for, and can't find one. My stock BF runs a .700 gritted, and gets me to 23mph so far, still tuning the high. My buddy's SuperBF RC26 goes about 29-30mph on an .800, and he says he should be 5mph faster. Any help is greatly appreciated. As an example my stock GSR25 geo chain,with 6/76, goes 29mph with decent acceleration, which is about as best as one can expect.

  • #2
    Ah man my MM is going to be slow as hell then. I am sure the super long stock spindle is under .800

    Comment

    Working...
    X