Announcement

Collapse
No announcement yet.

Engine mount bearing

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Engine mount bearing

    Hi
    I'm trying to replace engine mount bearing
    but it is too easy to put&pull bearing
    it doesn't need heat to put&pull
    Is it normal, or It's on last legs?
    This mount is old goped engine mount from gtr46
    Attached Files
    Last edited by chojja; 02-04-2021, 02:48 AM.

  • #2
    Can you remove it with your hands only?As long as there is no play its ok, the snap rings holds it in place. But it should be tight and snug

    Comment


    • #3
      Originally posted by LA8PV View Post
      Can you remove it with your hands only?As long as there is no play its ok, the snap rings holds it in place. But it should be tight and snug
      Yes, I can remove it with my hands only.
      I think i should buy new mount.
      Thanks for reply

      Comment


      • #4
        I have the same issue, going to buy a new one. Not shure if there are any difference in quality of the goped vs ddm. The ddm is less expensive tho

        Comment


        • #5
          Originally posted by LA8PV View Post
          I have the same issue, going to buy a new one. Not shure if there are any difference in quality of the goped vs ddm. The ddm is less expensive tho
          I will buy ada mount

          Comment


          • #6
            This is what you want.
            You do not have permission to view this gallery.
            This gallery has 1 photos.

            Comment


            • #7
              I had the same issue on my 54mm engine mount on my gsr25. I think I’ll need a whole new mount since a new bearing slides in and out effortlessly like you said. I just put a tiny bit of jb weld around the outside of the bearing and slid it back into place for now. But whenever I have another issue I’m buying a new mount

              Comment

              Working...
              X