Announcement

Collapse

General Forum Rules

This forum is open to all brands and aftermarket products.


No flaming or insulting other members, everyone is entitled to their own opinion.


Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!


No profanity. Dropping f-bombs doesn't make you cool.


Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

ADA Headkit problem, Marv???

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ADA Headkit problem, Marv???

    I just want to say that I have had a few other ADA ORC Headkits, and this is the only one I have a problem with.

    As I was riding the other day, my engine started to loose compresssion slowly, so I figured it was time to change the rings, because I had not changed them in a while, even though it seemed to loose compression real fast, I have never noticed a decline in compression that fast, but I figured that is the only reason. I took the billet head, dome, and ignition off, then when I went to take the cylinder off, I noticed the billet part that is mounted to the top of the cylinder was spining. I changed the rings, put it back together, and it still had no compression, I also replaced the gaskets today, still no compression at all. I tested the compression, and it did not even show up on my gauge.

    Out of my 3 other ADA ORC headkits, this is the only one that does this. I wanted to see if you guys would replace the cylinder, or tell me how to fix it if possible.

    A few pics.







    Evan Harris
    Ricochet Racing

  • #2
    If I screw it all the way on, I have good compression, but the flat part is no where near being close to the ignition.
    Evan Harris
    Ricochet Racing

    Comment


    • #3
      Fixed it
      Evan Harris
      Ricochet Racing

      Comment

      Working...
      X