Tweet
I HAVE A SET OF BIGFOOT ADA BILLET WHEELS IAM RUNNING ON MY GSR THE REAR WHEEL BEARINGS KEEP SIEZING ON ME BLEW TWO SETS OF BEARINGS WHAT SHOULD I DO NOT USE THE WHEELS ON MY GSR ARE THEY MADE FOR SUPERBIGFOOTS ONLY ? THANKS <(((><
-
-
Are you using the bearing spacer from the stock wheel? If you are not using a spacer between the bearings, then that is why your bearings keep going out. The ADA billet Bigfoot?/GSR? wheels do not come with the spacer, you use the one from the stock wheel. -
BILLET WHEELS
HI BROOKS YA I HAVE BEEN USING THE SPACER BETWEEN THE BEARINGS I JUST PUT MY STOCK MAGNESIUM GOPED RIMS BACK ON THEY SEEM TO ROLL BETTER. I PUT THE ADA ON BACK ON MY SUPERBIG FOOT WHEN I TIGHTN THEM UP THEY DONT TURN SO WELL. I CANT AFFORD TO BURN UP BEARINGS ON MY GSR TSI FUULY MOD TO THE GILL ALONG WALK BACK TO THE CAR MY AVG RIDE IS ABOUT 25 MILES SO WHAT ELSE COULD BE WRONG WARP WHEEL????? THANKS
Comment
-
When you bolt the wheel together, is the bearing spacer loose between the bearings? Maybe the stock spacer that you have is a little short. If the spacer is short, the bearings will bind up when the axle is tightened, just like of there was no spacer. I know the stock mag wheels to not have very good tolerances on the bearings and the spacer may not be as critical. On the mag wheels on our GSR the bearings just fell right out, no press fit.Comment
Comment