Announcement

Collapse

General Forum Rules

This forum is open to all brands and aftermarket products.


No flaming or insulting other members, everyone is entitled to their own opinion.


Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!


No profanity. Dropping f-bombs doesn't make you cool.


Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

Uhh...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Uhh...

    What do you gotta do, for that when you start pushing your ped with your feet the engine starts? Is it an upgrade or just kick off and push and it'll start? Or What?
    Goped: Yellow Bigfoot w/ ETT Pipe, HP carb, air filter, .750 spindle

  • #2
    I depends what kind of ped you have but if you have your spendle tight, and when your riding like a skate board and you here the engine turning over it should start..

    Comment


    • #3
      i have a bigfoot, .750 spindle, I guess its tight...ifnot tell me how to tighten it...but it doesnt start going
      Goped: Yellow Bigfoot w/ ETT Pipe, HP carb, air filter, .750 spindle

      Comment


      • #4
        You need a lockdown for the bf if you want to push start it. When you get a lockdown it will eliminate the clutch.
        AGperformance

        Jeff Stutz

        Comment


        • #5
          i see...an where can i get a lock down?
          Goped: Yellow Bigfoot w/ ETT Pipe, HP carb, air filter, .750 spindle

          Comment


          • #6
            Originally posted by Goped8
            i see...an where can i get a lock down?
            scratch that, i found out...how do i install it...I know I have to put the screw for the bottom in the little tube by were the gaslines and gear cable runs, but where do i attach it to the internet
            Last edited by Goped8; 07-18-2003, 08:43 PM.
            Goped: Yellow Bigfoot w/ ETT Pipe, HP carb, air filter, .750 spindle

            Comment

            Working...
            X