HP Carb Adjustments

[jtl900]

Well I've seen two possible settings for the mixture screws on the HP Carburetor for the G23LH engine. One says the lowspeed should be 1 1/2 turns out and the highspeed 3/4 turns out, and the other says lowspeed: 1 turn, and highspeed: 1 1/2 turns. I'm not sure which to run because both came from very reliable sources.

My Go-Ped:
G23LH w/ the following mods.
ADA HP Carb Kit
Timing Advance Key (10 degrees)
.800 Spindle
K&N Shielded Filter & Velocity Stack
3rd Bearing Support


P.S. Is there a lengthened throttle cable I can buy?

[cmatute12]

low should be 1 1/4
high should be 1 3/8

[GoPedMoron]

Just set your carb to either of the settings and then fine tune it.