General Forum Rules

This forum is open to all brands and aftermarket products.

No flaming or insulting other members, everyone is entitled to their own opinion.

Treat others how you want to be treated. If you do not have anything nice or productive to say, then don't say anything at all. Remember, you are interacting with real people and if you wouldn't say it to their face, then you probably shouldn't type it. Don't be a keyboard warrior!

No profanity. Dropping f-bombs doesn't make you cool.

Absolutely no obscene or pornographic content is allowed

Please post in the appropriate sections

Do not email, PM, call, or carrier pigeon etc. ADA Racing or admin with complaints about bans or Billetboard drama. If you were banned, it was for a reason and we're too busy to deal with those kind of complaints. If you have an issue with a moderator, please PM said moderator or any of the other moderators and if they have time to address it they will. Remember, we offer this board as a service to the community and it is a privilege to be on here, not a right.

Any member violating the above rules will be banned

These rules may be updated at any time
See more
See less

darn that superior bbk!

  • Filter
  • Time
  • Show
Clear All
new posts

  • darn that superior bbk!

    i have a speedwerx pipe got the bbk to make my lh a hybrid ( specs in my sig) and i was putting my manifold for my pipe on and the holes are too far apart so my pipe manifold wont go on. i was verry disapointed!
    goped sport with SUPERIOR BIG BORE KIT (hybrid), ada superior blue air filter, walbro hp carb, superior stock crank, case stuffer, extreme toys .750 spindel and 3rd bearing, blue cool head, lightend flywheel andvanced timing, speedwerx pipe, oversized gas tank, blue engin trix ripper billet deck, chrome bothy forks. go here and click on pics of me goped to see what it looks like
    AIM- culejoe28

  • #2
    The problem is that your header is setup for a Lh cylinder. Normally, headers have elongated holes so it will mount up to the Lh cylinder and Rc cylinder very easily since the distance between the two bolt holes are furter apart from that of a Lh. Its not the cylinder, its your header design.
    Ada All the way.