I cant get my goped started I have checked to see that its sparking, the compression is good, I have the 3 base gaskets, the pulse hole wasn't covered, the gas was around 94 octane, gaskets were all intact( till I pulled it apart to check the pulse hole then I ripped the gasket that connects the boost box to the cylinder), I took the boost box off, poured a little gas down through the spark plug hole and after doing all these things it wont start for me I have tried all the low speed screw combinations 1-4 by 1/2 increments and 1/4 increments between 1 and 2. What else left is there to check? The gopeds specs are in my signature (except for the pipe i just have the stock muffler on). This goped has never been ran before also.
My setup is as follows:
superior Chrome sport frame, superior front suspension, chrome gas cap, chrome engine cover, engine trix air scoop, he23hp, g230rc pipe, ADA 2mm stroker, superior g230rc bbk, Slippery nickel big bore piston, pro flow pipe manifold, 1.5 liter gas tank, steel ftg, SRE race port cylinder, SRE race port cases, SRE piston mod, SRE carb porting and blueprinting, SRE supercooler, SRE Lightened flywheel, g230rc cool head, engine trix billet deck, black magic .750 spindle
My setup is as follows:
superior Chrome sport frame, superior front suspension, chrome gas cap, chrome engine cover, engine trix air scoop, he23hp, g230rc pipe, ADA 2mm stroker, superior g230rc bbk, Slippery nickel big bore piston, pro flow pipe manifold, 1.5 liter gas tank, steel ftg, SRE race port cylinder, SRE race port cases, SRE piston mod, SRE carb porting and blueprinting, SRE supercooler, SRE Lightened flywheel, g230rc cool head, engine trix billet deck, black magic .750 spindle
Comment