Announcement

Collapse
No announcement yet.

carb tuning....pain in the @$$

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • carb tuning....pain in the @$$

    yes... i need to tun my carb because it sounds like its getting to MUCH gas so im just ganna re-tune it. what are good tuning ratio's? how many tunes on HIGH and how many on LOW? also...after i set those ratio's how much should i turn each screw left/right to get perfectness??? thanx in ADV
    red sport, HE23HP engine, ECC pipe, air filter, .800 longdrive w/ 3rd bearing, BEADLOCK...ALL SPEED!
    (selling pipe...if anyone wants to buy it IM me on STiLLBaLLiN937 on AIM. good pipe..adds ALOT of torque and insane powerband)

  • #2
    1 1/4 out for high
    1 1/2 out for low
    then tweek it out
    Moderator@GPN
    100% A - m - e - r - i - c - a - n -~- M - u - s - c - l - e
    2002 Super X Ped w/
    -G230RC, BBK, Meyer 1mm Stroker, ADA S1, TGN chrome fancover/scoop, tgn chrome shroud, tgn flame filter, HP Carb(Wa 167), .800 long drive, ADA Chrome 3rd bearing, ET Stem, ADA 16" Bars, Chrome Slidetube, Steel FTG, Lexan Deck, GetAPed Red Tank skin, Competitor rims

    Comment


    • #3
      What should you do to fine tune your carb? You have to experiment, you have to do a test pull from a dead stop to top speed. Fiddle with each needle sligtly and test.
      Ada All the way.

      Comment


      • #4
        Slimcandy is right. Just start it up and have a reguler screw driver and just fiddle with it until it sounds right.

        Comment

        Working...
        X
        😀
        🥰
        🤢
        😎
        😡
        👍
        👎