#219 chain compatibility

[Jaeb]

Not real sure if the board here is the correct one, but I am looking at a #219 / 91 tooth sprocket hooking to #25 / 7 tooth driver gear.

The pitches are 7.774mm / 6.35mm [about 1.4 mm diff (0.7mm to each side of tooth)]
respectively.

(I could add...

[Trent.myers]

I'm about to put a top end in my g230rc I'm looking at this 29cc bore up kit what do you guys think. Are there better kits?

[Super MXPed]

https://youtu.be/B9jCv8rmWbA

full movie “progressive” such an iconic film...

[Buckeyeguy]

GoPed GSR Sport with centrifugal clutch. Just installed new replacement clutch and springs. Unit ran great for two weeks and then clutch spring failed again. Has anyone else had this problem? Anyone have ideas why this is happening or has anyone had success with upgraded springs or developed a fix for...

[Super MXPed]

Drew up my first test of an engine guard this is v1. Came out ok it is in TPU a flexible filament so it has give but still does it’s job. Think I’ll make two versions one for a block off one for pullstart it sticks further out than necessary without the pull start.

Final version will...

[Super MXPed]

Super xped and super sport lh-rc hybrid with grind plate...

[Super MXPed]

After a 5 year hiatus Goped has called me back.. I built a nice super xped with all the goodies in 2016.
F270 w/ ada head kit, raw jetpro rc pipe, powder coated pearl white xped frame, carbon fiber deck, mico suspension forks, rancho race clamp, ada bars, Hollywood scoop, ddm billet AF, billet...

[Trent.myers]

I'm not sure what ped I have it has a g230rc. And is a air tire ped

[Trent.myers]

I have a goped superbigfoot with a g230rc engine walbro carb. It is extremely unreliable. when you go to high rpm you can't come down too fast or it will abruptly die and be hard to start again. Its powerband is almost gone to the point I thought the spindle was slipping but it was just had no power....

[andrew]

Anyone in Arizona do tune ups on some older go peds built by sidewalk surfer???